CR and CRE pumps are stainless-steel vertical multistage pumps (CRI and CRIE all stainless steel up to size 20, cast iron and stainless steel above), with an HQQE silicon carbide cartridge shaft seal that can be replaced without dismantling the pump. The MGE motors of the CRE pumps incorporate the frequency converter; above 30 kW or on MPC-F sets, the frequency converter is installed in the cabinet. Each pump can be removed without touching the pipework thanks to its isolating valves and its non-return valve: maintenance of a six-pump booster set is carried out pump by pump, without cutting off the water. Stainless-steel EN 1.4401 manifolds with R 2 to R 2½ union connections or DN 80 to DN 250 flanges, operating pressure 16 bar as standard (higher on request), liquid from 0 to 70 °C.
The CU 352 cabinet controls the whole set from its colour touch screen: constant-pressure control with redundant primary sensor, automatic cascade control, alternative setpoints, limitation of starts per hour, standby pumps, forced pump changeover, periodic pump test run, dry-running protection by pressure switch, level switch or analogue sensor, low-flow stop function, password. The IO 351 modules add inputs and outputs; the G100 gateway and the CIM modules open the booster set to remote monitoring (GENIbus, Modbus, PROFIBUS, GSM). Cabinet options: main switch with neutral disconnection, manual-off-auto selector switch, indicator lights, beacon and audible alarm, voltmeter and ammeter, phase asymmetry monitoring, surge arrester.
The booster set is delivered assembled and tested, on a stainless-steel or galvanised base frame depending on the version, for indoor installation on a concrete foundation with a mass equal to 1.5 times its own, with 1 m of clearance in front and on the sides. The MPC-E 2 and 3 CRE 10 to 64 and MPC-F 3 CR 15 versions in the Grundfos catalogue cover from 22 to 308 m³/h rated flow and up to 149 m; configurations with 4, 5 or 6 pumps, CR 90 pumps, pressures above 16 bar and custom-built booster sets are produced by Grundfos on request from your flow and pressure requirements.
Applications: water supply and distribution for towns and districts from a storage tank, filling and pressure boosting of water towers, large hospitals and hotels, campuses and barracks, industrial estates, pressurised collective irrigation, NGO and local-authority projects worldwide.
After the solar borehole: a booster set takes over from an SP borehole with RSI inverter that fills the tank or the water tower during the day; it then distributes the stored water at constant pressure, powered by the mains, a generator or a solar system with storage and three-phase inverters (Victron, Studer, SMA Sunny Island X). We size the whole system, from the borehole to the network; see the Grundfos system from A to Z and solar water supply.
Official Grundfos distributor, SINES Export supplies Grundfos booster sets to installers, operators, engineering firms, local authorities and NGOs, for worldwide export: selection of the booster set from your flow and pressure requirements, tender documents, sea or air freight logistics, remote commissioning.
Official Grundfos documents. Full data booklet, curves and dimensional drawings for each configuration on the Grundfos Product Center or on request from our team.
Need sizing or a schematic diagram? Contact us: we assemble the complete system.