A MultiPlus with ESS (Energy Storage System) functionality
The MultiPlus 48/20k is a multifunctional inverter/charger with an external current sensor option. It is suited to professional marine, yachting, vehicle and land-based off-grid applications.
PowerControl and PowerAssist – boosting the capacity of the grid or a generator
A maximum grid or generator current can be set: the MultiPlus takes the other AC loads into account and uses whatever is extra for battery charging, preventing the generator or grid from being overloaded (PowerControl). PowerAssist goes further: where peak power is required only for a limited period, the MultiPlus compensates for insufficient generator, shore or grid power with power from the battery, and the spare power is used to recharge the battery when the load reduces.
Two AC outputs
The main output has no-break functionality: in the event of a grid failure, or when shore or generator power is disconnected, the MultiPlus takes over the supply to the connected loads so fast (less than 20 milliseconds) that computers and other electronic equipment continue to operate without disruption. The second output (50 A) is live only when AC is available on the input of the MultiPlus; loads that should not discharge the battery, such as a water heater, can be connected to it.
Solar energy: AC power available even during a grid failure
The MultiPlus can be used in off-grid as well as grid-connected PV and other alternative energy systems, and is compatible with both solar charge controllers and grid-tie inverters. In a grid-parallel topology, it uses the data of the optional external AC current sensor (100 A, to be ordered separately) or of a power meter to optimise self-consumption and, if required, to prevent feed-in to the grid; during a power outage, it continues to supply the critical loads.
Three-phase and parallel operation
Three units can be configured for a three-phase output. For parallel operation, Victron recommends an external AC transfer switch.
Configuration and monitoring
Settings can be changed in a matter of minutes with the VEConfigure software (computer or laptop with the MK3-USB interface). Monitoring and control options include the Ekrano GX, the Cerbo GX, a laptop or computer, Bluetooth with the optional VE.Bus Smart dongle, a battery monitor and the Digital Multi Control Panel. With a Cerbo GX or another GX product connected to the internet, operational data can be stored and displayed on the VRM (Victron Remote Management) website, and settings can be changed remotely.
Main technical data (official datasheet)
• DC input voltage range: 38-60 V
• Output: 230 VAC ± 2 %, 50 Hz ± 0,1 % (can be adjusted to 60 Hz)
• Continuous output power: 20 kW at 25 °C, 18 kW at 40 °C, 14 kW at 65 °C; maximum apparent feed-in power 20 kW
• Time limited output power (cold start): 21 kW for 5 hours; peak power 25 kW for 1 min
• Maximum efficiency 96%; zero load power 65 W (40 W in AES mode, 13 W in Search mode)
• Charger: AC input voltage range 187-265 VAC, 45 – 65 Hz; absorption 57,6 V, float 55,2 V, storage mode 52,8 V; maximum battery charge current 250 A at 25 °C, 240 A at 40 °C
• Transfer switch and maximum AC input current: 100 A; auxiliary output 50 A
• Enclosure: aluminium, blue RAL 5012, IP20; battery connection four M8 bolts (2 plus and 2 minus), 230 VAC connection M6 bolts; operating temperature -40 to +65 °C (fan assisted cooling)
• Weight 80 kg; dimensions (h x w x d) 616 x 422 x 357 mm